26
The following inspections shall be performed on your engine at the
indicated intervals or more if needed. These inspections ensure that your
engine will continue to perform at a level it was designed to. Make sure that
all inspections are performed at their assigned intervals.
100 Hour Inspection
WARNING:
Make sure key is not in ignition and no electrical
equipment is energized prior to any engine check or operation. Do not
energize engine prior to performing the following steps.
1. Open engine hatch cover and let compartment air out for ten minutes or
more.
2. Make sure that no electrical equipment is energized
3. Change engine oil and filter.
4. Check coolant level Make sure fluids are at the proper level.
5. Check for oil, coolant, and fuel leaks, Correct any leaks prior to proceeding
further.
6. Check charge and fluid level of battery. Inspect connections for corrosion,
and clean as necessary.
7. Clean crankcase vent system.
8. Check air cleaner Make sure that it is cleaned replaced as necessary.
9. Inspect the exterior of the heat exchanger clean if necessary
10. Check serpentine belt for wear.
11. Check for loose bolts, nuts, or any loose pieces.
12. Start the bilge blower, Let the blower run for 10 minutes.
13. Close engine cover.
400-Hour Inspection
Perform the following inspection on your engine at the 400-hour interval.
WARNING:
Make sure key is not in ignition and no electrical
equipment is energized prior to any engine check or operation. Do not
energize engine prior to performing the following steps.
1. Open engine hatch cover and let compartment air out for ten minutes or
more.
2. Make sure that no electrical equipment is energized
3. Change engine oil and filter.
4. Check coolant level Make sure fluids are at the proper levels.
