Koden MDC-5004, Руководство по установке

Страница: 75 / 156

MDC-5000 Series Chapter 4 Setup after installation
0092653004-00 4-21
4.2.10 Changing baud-rate of input/output ports of navigation devices.
When the data is correctly input in each port and is not displayed on the display, the baudrate of signals
(4800 or 38400bps) may be unmatched. In this case, display [INPUT] menu mentioned in 4.2.9, and
confirm that a mark is displayed at the intersection point of the input sentence and the input port. When
a mark is not displayed, set each baudrate of input/output so as to match with those of connected
sensors with input sentences.
Default value per port is set as follows:
J3: 38400bps
J5: 4800bps
J6: 4800bps
Example of change of setting: J3 port 38400 bps => 4800 bps
Press MENU
key to display “Menu”.
Select [MAINTENANCE] => [I/O] => [BAUDRATE] => [J3] => [4800] and set with ENT key.
4.2.10.1 Setting all I/O ports automatically
This radar can set the format of all I/O ports automatically by following procedure.
(1) Press MENU
key to display “Menu”.
[MAINTENANCE] => [I/O] => [BAUDRATE] => [AUTO SETUP] => [GO], and press ENT key.
About 30 sec. later all I/O ports can be set by input signals connected to external devices.
4.2.11 Setup KGC (GPS compass)
When connect KGC (KODEN GPS compass) to the J6 port, please set KGC to set format and output
sentences.
Press MENU
key to display “Menu”.
Select [MAINTENANCE] => [I/O] => [KGC SET] => [INITIAL] => [GO], and press ENT key.
Data 1 or Data 2 in KGC-222 and J6 port of the radar are optimally set.
Caution: With this initialization, Data 1 or Data 2 (port connected to the radar) of KGC-222 is set at
38400 bps for baud rate, 50ms for signal cycle, and HDT, GGA, VTG, DTM and ZDA for signal type.
Bearing correction of KGC-222
When the mounting direction of KGC-222 has been out of alignment, compensation of the
misalignment allows KGC-222 to output HDT signal as follows.
(1) Press MENU
key to display “Menu”.