Koden MDC-5004, Руководство по установке

Страница: 69 / 156

MDC-5000 Series Chapter 4 Setup after installation
0092653004-00 4-15
4.2.3.3 How to input the heading value by manual
The heading data can be set by manual for the purpose of an examination or repair.
Setting can be performed with pressing MENU key as follows:
(1) [MAINTENANCE] => [I/O] => [HDG] => [HDG] => [MAN], and press ENT key.
(2) [MAINTENANCE] => [I/O] => [HDG] => [MAN] => [VALUE] will show the current setting of the input
value by highlighting the last digit value by the joystick.
(3) Move the joystick up or down to set the value. Press ENT key to save the set result.
Setting value: 0.0 to 359.9°
Note: The manual input data is displayed with yellow color.
4.2.3.4 Compensation of angle of ship
’s bearing
When there is any constant error in input ship
’s bearing, it can be used after compensated as follows:
(1) Press MENU key to display
“Menu”.
[MAINTENANCE] => [I/O] => [HDG] => [OFFSET] => [VALUE] will show the current setting of the
input value by highlighting the last digit value by the joystick.
(2) Move the joystick up or down to set the value. Press ENT key to save the set result.
Setting value: 0.0 to 359.9°
Example: OFFSET value: 10°
4.2.4 Setting of STW to be used for SEA STAB
Select an input device for STW to be used for TT (ATA), AIS, TM, True Trail and OS Past track at
stabilized speed against water.
In case of speed meter against water with pulse output such as LOG, the output shall be put of this unit
after conversion of the signal into that of NMEA signal through LOG converter unit inserted between
them.
Speed signal from GPS compass or GPS can be also input. For setting of this, use of [AUTO] is
recommended as shown below.
(1) [MAINTENANCE] => [I/O] => [STW] => [STW] => [AUTO], and press ENT key.
Set values: AUTO, VHW, VBW, VTG, RMC, RMB, RMA, MAN, CURRENT
LOCAL 21/01/16 10:18
HDG GYRO
230
°
LOCAL 21/01/16 10:18
HDG GYRO
240
°