Kodak VERSAMARK DP5120, Руководство по установке

Страница: 65 / 82

Installation Guide 6-1
Chapter 6. Testing
This chapter describes the following procedures for checking the
installation:
• Electronics test
• Fluidics test
• System test
• Printhead Adjustment.
Note: These tests can also be done using Jetscape diagnostics if you have that
program available on the controller or a service laptop.
To ensure that you completed all steps of the installation procedure, use
the checklist in “Appendix A. Installation Checklists”.
Electronics Tests
Use the following procedure to powerup the system and run the automatic
powerup confidence checks (POC).
1. For a printing system, turn on the main power switch (on the power
distribution panel). For a printer, check that the line switch on the back
panel is in the online (|) position.
2. While holding the OPEN EYELID button, press the PRINTER ON
button.
3. Continue to hold the OPEN EYELID button until all lights on the front
panel are illuminated.
4. Release the OPEN EYELID button.
5. On a printing system, turn on all the components.
6. Check for error messages that indicate a POC failure.
7. If no errors occur, continue with “Fluidics Tests”. If an error message
is generated, note what type of failure occurred and continue with
step 8.
8. Start diagnostics and run the test on the failed component.
Note: See the Service Guide for diagnostics and troubleshooting procedures.
9. If the component fails again, troubleshoot the problem and replace
the component, if necessary.