Kodak VERSAMARK DP5120, Руководство по установке

Страница: 23 / 82

Installation Guide 2-7
Chapter 2. Unpacking
Printing System
14. Unlock the printing system enclosure (cabinet) caster locks.
Caution: The following steps should be done by two persons. If you are alone,
exercise additional caution.
15. If two persons are available, tilt the cabinet slightly toward either of its
long sides, and then pull any packing material under it out. If you are
alone, cut away any packing material underneath the cabinet that
blocks the casters
16. Roll the cabinet down the ramp and onto the floor.
17. Stop the cabinet when it is level with all four casters on the floor and
lock the casters.
Hint: It is easier and safer to pull the cabinet down the ramp rather than to push
it down. The printer weighs approximately 100 lbs (45 kg), and pulling the
cabinet down allows you to guide and slow it as it moves down the ramps.
Caution: Do not let the cabinet roll free or tip more than 20 degrees as it moves
down the ramps.
18. Remove any packaging material from inside the cabinet.
19. Remove the umbilical and printhead housing from inside the cabinet
and coil the umbilical on top of the cabinet and nest the printhead
housing within the coils.
Note: Leave the protective packaging on the printhead housing. This packaging
should not be removed until you perform the printhead installation (see
“Printheads”).
20. Roll the cabinet to where the printing system is to be installed.
21. Continue with the printing system installation procedure (see “System
Inventory”).