Kodak VERSAMARK DP5120, Руководство оператора

Страница: 33 / 66

Operator’s Guide 2 - 7
Chapter 2. Basic Operation
Operating Procedures
Idle Time Guidelines
You can leave the printer on indefinitely without printing; however, if
leaving the printer idle for more than 1 hour, you can extend ink life by
following the guidelines in Table 2.3.
Turning Off the Fluid System
To turn off the fluid system, press [STANDBY]. During power down, the
[STANDBY] light flashes at a faster rate than it does at power up; the
[STANDBY] goes off when the fluid system is completely powered down.
Some ink remains in the printhead. The printer can be left in this state for
up to 7 hours.
Turning Off the Printer and the Fluid System
To turn off the printer and the fluid system, press [PRINTER ON]. The
[PRINTER ON] and [STANDBY] lights flash rapidly and go off when
power-off is complete (approximately 5 minutes).
Clearing Errors
When an error is detected, the [ERROR] light comes on. If the error is an
inkjet short (IJ-42) error, the [ERROR] light flashes. To clear an error,
press [OPEN EYELID]. The status of the eyelid remains the same.
Table 2.3 Idle time guidelines
Idle Time Procedure
Less than 1 hour Leave printer and fluid system on and close the eyelid.
Open the eyelid to continue.
1 to 7 hours Turn off fluid system. Perform a printhead clean to restart.
7 hours to 7 days Turn off fluid system and printer. Power on printer and fluid
system to restart.
More than 7 days
See the 5000 Series
Service Guide
for long-term
shutdown procedures.