7
• Insert the outlet box wires into the side of
the terminal block.
• Insert the white wire from the outlet box
into the terminal marked “N (White)”.
• Insert the black wire from the outlet box
into the terminal marked “ L (Black)”.
• Insert the green ground wire from the
outlet box into the terminal marked “GND”.
• Align the bottom edge of the Security Floodlight with the bottom edge of the
Mounting Plate . Tilt the Security Floodlight toward the Mounting Plate ,
making sure the Security Floodlight is centered on the Mounting Plate .
• Tighten the Large Mounting Bolt securely through the center of the
Mounting Plate . Do not overtighten.
• Push the Decorative Knob firmly into the mounting bolt hole on the light
Security Floodlight .
• Apply caulking around the canopy and
mounting surface with silicone sealant
(not included).
Note: If you install this light fixture on
the covered wall or eave without a outlet
box, you must use the appropriate
screws (not included) to install this
light fixture on the covered wall or
eave directly depending on the surface
(replaces or ).
STEP 3. MARKING THE ELECTRICAL CONNECTIONS
STEP 4. MOUNTING THE SECURITY FLOODLIGHT
STEP 5. CAULKING AROUND THE SECURITY FLOODLIGHT
PC
PC
PA
PA
PA
PA
PA
PH
PH
PH
PD
PD
PD
PD
PD
PF
PG
Large mounting bolt
(pre-installed)
