Dynamic Acera 03/05 Rev. 05
Page 3-40
2. KPSS Release Switch – FIGURE 3.32.a
When the LCD screen displays“CPU
MECHATRO CONT.FAIL”, proceed as f o l -
lows:
a.
Stop the engine.
b.
Remove the covers for the control panel
located behind the operator’s seat:
b1.
Turn the top 4 screws CCW 90 º to
unlock them, press the lower locks to re-
lease the cover. Disconnect the speaker
wires and remove the top cover.
b2.
Press the lower locks to release the
bottom side of the lower cover.Then re-
move cover.
c.
Locate the switches for the KPSS release
and the swing parking brake release
switch and flip them to their release posi-
tion.
d.
Install the covers.
FIGURE 3.32.a
FIGURE 3.32.b
CPU
FAIL
MACHINE FAMILIARIZATION
FIGURE 3.32.c
REMOVE ROD LINKAGE
DISCONNECT HARNESS
CONECT MANUAL
THROTTLE CONTROL
CABLE HERE
SCREEN
CHANGE
SWITCH
NOTE
The SK480 and M/C SK330 uses the
Mitsubishi Electronic Controlled Injection
system. There is no manual throttle control
cable available for this model.
Manual Throttle Cable – FIGURE
3.32.b
This mechanical system is used to control the
engine speed manually if the electronic sys-
tem fails to operate properly.
a.
When the LCD screen displays “STEP
MOTOR S/PT ERROR ” and the engine
speed can ’t be controlled normally, press
the button at the center of the knob and
simultaneously pull the cable control to
raise the engine speed to high idle
conditon.
b.
When the LCD screen displays “CPU
MECHATRO CONT.FAIL.” and the engine
speed can’t be controlled nomally, pro-
ceed as follows:
