Dynamic Acera 03/05 Rev. 05
Page 3-56
MACHINE FAMILIARIZATION
PATTERN CONTROL CHANGE
A.
To change the machine’s control pattern from
SAE to Back Hoe Loader pattern, proceed as fol-
lows:
1.
Place the attachment on the ground, throttle
control in low idle, and turn the ignition key
off.
SAE PATTERN
BHL PATTERN
C.
Slowly operate Left Hand
control to make sure it
matches BHL pattern and
to familiarize yourself with
the new control pattern.
BHL LH Control
SWING RIGHT
SWING LEFT
LH CONTROL LEVER
BOOM DOWN
BOOM UP
D.
Slowly operate Right
Hand control to make
sure it matches BHL pat-
tern and to familiarize
yourself with the new con-
trol pattern.
BHL RH Control
ARM OUT
ARM IN
BUCKET OUT
BUCKET IN
RH CONTROL LEVER
DO NOT OPERATE MACHINE UNLESS YOU HAVE READ
AND UNDERSTOOD THE INSTRUCTIONS IN THE
OPERATOR’S MANUAL. IMPROPER MACHINE OPERA-
TION IS DANGEROUS AND COULD RESULT IN INJURY
OR DEATH.
WHENEVER A CHANGE IS MADE TO THE MACHINE’S
CONTROL PATTERN, ALSO EXCHANGE THE PATTERN
DECAL IN THE CAB TO MATCH THE NEW PATTERN.
SAE PATTERN
BHL PATTERN
B.
Make sure to place
the BHL pattern
plate in its respec-
tive holder, located
below the cab door
handle. Make sure
BHL pattern is
showing.
2.
Place the safety le-
ver in the lock and
up position before
leaving the cab.
SHOULD THE CONTROL PATTERN DECAL-CARD IS
LOST, ORDER P/N: YN20T01476P1.
CHECK MACHINE’S CONTROL PATTERN FOR CON-
FORMANCE TO PATTERN ON DECAL-CARD IN CAB. IF
PATTERN DOES NOT MATCH DECAL-CARD ON CAB
DOOR HOLDER, FLIP DECAL-CARD ON HOLDER TO
MATCH THE MACHINE’S CONTROL PATTERN BEFORE
OPERATING MACHINE. FAILURE TO DO SO COULD RE-
SULT IN INJURY.
YN20T01476P1
YN20T01476P1
3.
Open the air cleaner compartment door, lo-
cate the pattern changer valve and change
valve’s handle postion from “I” (SAE) to “D”
(Back Hoe Loader).
WARNING
DANGER
WARNING
WARNING
