Page 3-43
Dynamic Acera 03/05 Rev. 05
NOTE
1. The fuel level and engine water, work lights,
wiper, air-con, radio, etc. on the cluster
gauge function rely on the C-1 Controller to
function in normal condition. With out the
C-1
controller function, operate machine with
caution and watch engine and hydraulic
conditions.
2. Machine function is performed at almost
90% the same level as when in the normal
condition with the controller.
3. The backup functioning time has only slight
effect on the performance of the machine,
but inspection and repair are required to
correct the trouble.
4. Should gauge cluster display fail, the fuel
level and E/G water temperature are not
indicated, also other cluster gauge function
are not possible.
5. Also, for the failure shown in Item 4, it may
cause trouble with daily operation, so
immediate inspection and repair are
required.
6. When the hydraulic pump is set to the
backup function, the control of KPSS work
mode switch is not required.
Back-up function - cont.
Installing Manual Throttle Cable (Pre M/C)
1. Place throttle at low idle. Start the engine.
2. To increase engine speed, press the
center button of engine control knob, and
simultaneously pull cable control to raise
the engine speed to to be maintained.
(See Figure 3.35.a)
3. Resume working
4. After finishing the work, press the center
button of engine control cable and
concurrently push down the knob, and the
engine speed returns to low idling.
5. Stop the engine by pulling the emergency
stop cable, then turn off the keyswitch.
Figure 3.35.a.
MACHINE FAMILIARIZATION
NOTE
The above manual throttle assembly is not
available on the SK480.