49
9. Care and maintenance
9.2 Cleaning
Clean the machine each time after grinding to
prevent the grinding sludge from drying, which
makes it harder to remove.
After cleaning, lightly grease the grinding machine
with non-corrosive oil (also refer to the lubrication
schedule, section 9.1.1).
Replace coolant daily and clean container.
ATTENTION
The polishing and deburring rings cannot be
wet, as they can only accept the polishing
paste and properly deburr the knife when
dry.
The cross table parts cannot become wet.
Under no circumstances should the machine
be sprayed using a high-pressure washer.
Empty the suction unit tray (9-2/1) once per week.
ATTENTION
Push the tray until reaching the stop under
the machine, otherwise the suction unit will
not work at full capacity.
Figure 9-1
Interior
Figure 9-2
Suction unit tray
1
