36
7.3 Changing the polishing / deburring rings and polishing paste
To replace the polishing and deburring rings, first
open and remove the cover (7-16/1) by turning
the two star handles (7-16/2).
The shaft must be attached using a SW10 spanner
(7-17/1) in order to then loosen the threaded nuts
using a SW 22 spanner (7-17/2).
NOTICE
After replacing the polishing / deburring ring,
perform a trial run. If the machine behaves
unusually, take it out of service and correct
the cause.
ATTENTION
The left shaft (7-17/3) has a left-hand thread.
To loosen the threaded nuts to the left, turn
clockwise.
The right shaft (7-17/4) has a right-hand
thread. To loosen the threaded nuts to the
right, turn counterclockwise.
7. Operation
Figure 7-16
Removing the protection hood
Figure 7-17
Replacing the polishing / deburring
rings
2
1
1
2
2
4
3
