DAD 6.1L/DAD 2.1L/MWD 2.1L user manual V6700, version 3.2
Troubleshooting
37
”Data acquisition
active”
No entries are possible. First stop acquiring mea-
surement data, afterwards you can make a new
entry.
E
”Error input acti-
vated”
External error, outside the device: Check the
external devices and cable connections.
Check the system to locate and remove the error.
H
”HAL lamp does not
start” (DAD 6.1L)
Switch the lamp on. In case the error shows again,
restart the device.
In case no improvement shows, replace the lamp.
I
“Instrument busy”
3D data is being collected while scanning, leak
sensor or cover are processing earlier inputs. Wait
until the device has completed the process.
“Instrument in
standalone mode”
Command can not be executed in local operation
(only in remote operation)
“Instrument in
standby mode”
Command not allowed during standby mode.
“Instrument not vali-
dated”
Data acquisition or simple scans can not be exe-
cuted, if the system has not been validated.
”Instrument remote
controlled”
This entry is not executable. Quit software.
L
“Lamp cover open”
The lamp cover was mounted incorrectly or the
micro switch is malfunctioning.
Mount the lamp cover. In case the system mes-
sage repeats itself, inform the Technical Support
of KNAUER .
“Lamp not installed”
GLP data can not be read and lamp operation can
not be executed, as the lamp (D2 or halogen) has
not been installed.
“Lamps off”
Command can not be executed, as the lamps are
being switched off.
“Lamp supply is not
available”
Power supply of lamp has not been installed or
does not react.
“Lamp supply tem-
perature limit
exceeded”
The upper temperature limit for power supply of
lamp was exceeded.
“Lamp unit tem-
perature limit
exceeded”
The upper temperature limit for lamp unit was
exceeded.
“Lamp unit tem-
perature sensor
failed”
Temperature sensor of lamp unit was not found or
does not react.
“Leak sensor failed”
Switch the device off and then on.
If the leak sensor is still not present, contact the
Technical Support of the manufacturer.
Leak sensor was not found or does not react.
System Message
Problem and Solution
