DOCUMENTATION OF AUTOMATIC CONTROL
FOR COMPACT UNITS
DTR.MCKT-HPX.
AUT-009.5.0
PAGE
GDYNIA
MCKT-HPX
2016
32/35
KLIMOR Spółka z ograniczon
ą
odpowiedzialno
ś
ci
ą
, 81-035 Gdynia, ul. B. Krzywoustego 5
Fax: (+48 58) 783-98-88; Tel.: (+48 58) 783-99-99
Service – Fax: (+48 58) 783-98-88; Tel.: (+48 58) 783-99-50/51 Mobile: (+48) 510 098 081
Information provided in this document is subject to change
email:
– Office
– Service
Register
address
Code
Description
Type
40035
RpOFFDurati
on
MSB: Delay after the system start, when the anti-frost protection
function is activated Rprot [min], {0÷59}
Read only
--
---
Read only
40036
ASTInt
MSB: Beginning of time interval in hours (1–23) in which the
device is stopped for the period determined by the ASDuration
(0x1F mask) parameter
Read only
ASDuration
LSB: Device stop time [min], {1÷30}
Read only
40037
RefSensHi
MSB: reference sensor temperature byte
Read only
RefSensLo
LSB: reference sensor temperature byte
Read only
Example of temperature calculation:
Tn = ((DS1_HI << 8) + DS1_LO )/16
E.g.: DS1_HI = 1, DS1_LO=120 -> Tn = 376/16 = 23.5 °C
Device start condition using COM2 (COM2ctrlSTART_bit bit in the 40019-MSB register):
- Setting the [COM2] = {YES} parameter at the DEN16-C panel
- Setting the [Ctrl] = {Rem} parameter at the DEN16-C panels
- turning-on DEN16-C panel: ON/OFF status
Note1
:
Once the power is turned on the communication via COM2 port is blocked during first 30
seconds.
Note:
Temperature calculation is required for: Tz,Tn,Tw,Tn2,Tr,Tp.
Note3:
The AIN0 analog input is an universal input. The [AinFn] parameter = {AI|DI} determines
the output function. For the UI1 and UI2 analog inputs selection of the input function
determines the UI1f i UI2f = {AI|DI} parameter.
Note4:
Reading registers starting from the 40030 address is possible from firmware ver. 2.10 (0x2A).
Device addressing
Device addressing is carried out using the S1MX dip-switch located on the MCKT-HPX control PCB.
The address is set by switching on individual bits of the binary word.
addr0 switch is for 0. Bit, addr1 – 1.bit, addr2 – 2.bit. Fn1 is not used.
Address 0 - reserved
