Klimor EVO-S COMPACT, Руководство по эксплуатации и обслуживанию, Страница: 39 / 88

37
b) for units (small where feet may be present but with a fra-
me) the support must not be smaller than 200x200mm and
located on the outer ends of the frame and in the middle of
its length (in place of the central crossbar) Fig. 16, Fig. 17.
Fig. 16
AHU on framework
Fig. 17
The frame for an air handling unit consisting of one monoblock with support
c) for monoblock AHUs and single blocks with a channel
profile frame support 200x200mm is required at the exter-
nal ends of the frame and in the middle of its Width (in
place of the central crossbar). However, support surface
300x200 mm is required in places where monoblocks or
unit blocks are connected Fig. No. 18.
Fig. 18 Frame for air-handling unit consisting of several monoblocks
3.2.2 Unit feet
For sections of EVO units that do not exceed a width of 2000 mm, i.e. from size 5100 to 5610, there is an optional possibility
to use adjustment feet.
Mounting of the feet should be done according to Fig. No. 19.
The threaded mandrel of the adjustment foot must be threaded through the 13mm diameter hole in the longitudinal
channel of the frame, providing it with flat pads and M12 nuts on both sides.
Fig. 19 Assembly of the unit foot
flat pads M12
nuts M12
adjustment foot