www.klever-mobility.com
www.klever-mobility.com
34
35
Rechargeable battery
Rechargeable battery
6.5.3 Removal and mounting of the
battery pack
The battery is automatically locked in place with the battery
lock and thereby protected from theft. To remove the battery,
first turn off the system using the On/Off button on the
display. Turn the key in the battery lock clockwise up to
the stop and pull out the battery with the handle from its
docking station (image 36). Now you can charge the battery
separately or store it safely for a longer break.
Having removed the battery pack from your speed pedelec,
please don’t forget to protect the contact connector of the
controller unit with the rubber cover. We advise to always use
the rubber cover when the battery is taken out of the docking
station (image 37).
Mounting the battery in the docking station
Insert the battery carefully. Make sure the groove of the
battery casing is carefully inserted into the guide rail of the
bicycle frame. Then slide the battery pack gently down until
you hear the lock engage and the electronic contacts are
connected (image 38). For this operation you do not need the
key of the lock. The lock will automatically snap in place and
the battery is now locked. The system is ready for operation
and the battery protected from being stolen.
Caution! Do NOT ride your X Speed model without
battery! Prior to starting the system, make sure to check
whether the electronic contacts of the battery are engaged
and locked in place. Riding your bike without the battery
could possibly damage the Klever BIACTRON system.
6.5.4 Transport of the battery
This battery is subjected to the Dangerous Goods
Legislation. The owner of the X Speed can transport the
battery by road and train without limitations and any
further requirements. However, when being transported
by third parties (e.g., forwarders, post or via air) special
requirements on packing and labelling of the battery pack
must be observed. For the preparation of the battery
being transported, consulting an expert for hazardous
material is absolutely required.
Ship the battery only when the casing is undamaged.
Tape or mask off open contacts and pack up the battery in
such a manner that it cannot move around in the packing.
And please also observe detailed national regulations.
Please note! In every case of transporting a broken or
damaged battery, always refer to an authorised Klever
dealer. The dealer can inspect the battery and, in case
necessary, forward the broken battery to Klever Mobility.
6.6 Elementary diagnostics and
troubleshooting of the electric system
The system will not turn on
Check all connections. Check whether the battery is sitting
correctly in the docking station in the frame and whether the
battery lock is engaged.
The system can be turned on, but does not give any
electric motor support
Check all connections from and to the rear wheel motor.
Please note! In case it is not possible to solve the above
problems, please contact your local Klever dealer or our
technical hotline.
Image 36
Image 37
Image 38
Rubber
seal
Contact
connector
