© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
802725
6
Connecting Hoses
This appliance is to be connected to the water mains
using new hose-sets and old hose-sets should not be
reused.
Remove the two plain rubber washers and two filter
screens from the accessories bag. Install them into
each end of the fill hoses as shown in
. The
screen must be facing outward.
Screw hose couplings with the filter screens onto the
water faucets until they are finger-tight. Then, using a
pliers, screw approximately 1/4 turn.
Screw hose couplings from other end of hoses onto the
water mixing valve until they are finger-tight. Then,
using a pliers, screw approximately 1/4 turn. Refer to
IMPORTANT: Do not cross thread or overtighten
couplings. This will cause them to leak.
Turn water on and check for leaks. If leaks are found,
turn off the water, unscrew hoses and reinstall them
until there are no leaks.
IMPORTANT: Hoses and other natural rubber
parts deteriorate after extended use. Hoses may
develop cracks, blisters or material wear from the
temperature and constant high pressure they are
subject to.
All hoses should be checked on a yearly basis for
any visible signs of deterioration. Any hose showing
the signs of deterioration listed above should be
replaced immediately. All hoses should be replaced
every five years.
IMPORTANT: Turn off water supply faucets after
check-out and demonstration. Owner should turn
off water supply whenever there will be an
extended period of non-use.
NOTE: Longer fill hoses are available (as optional
equipment at extra cost) if the hoses supplied with
the washer are not long enough for the installation.
Order hose as follows:
Part No. 1010102 – 2.5 m Fill Hose
TLW1976N
1
Water Faucet
2
Fill Hose
3
Plain Rubber Washer
4
Hose Coupling
5
Filter Screens
Figure 2
HOT
COLD
3
1
5
2
4
SWD596N
1
Water Faucets
2
Cold Water Connection
3
Hot Water Connection
4
Water Fill Hoses
Figure 3
SWD5
9
6N
1
2
3
4
WATER
MIXING VALVE
Содержание LTKA6
Страница 23: ......
