78
Figure 6-38
Figure 6-39
20)
Make certain the wire rope is tight against the Terminal Wedge in the Terminal.
21)
Attach the Wire Rope Clamp approximately 4 times the Wire Rope diameter from the Terminal as
shown in
Figure 6-40
and fully tighten the nuts to a torque value of approximately 80 lbf-inch (9 N*m).
Do NOT clamp the free end of the rope to the load bearing rope fall (the rope between the Terminal
and the Bottom Hook Block) see
Figure 6-41
.
Figure 6-40
Figure 6-41
22)
Insert the Terminal into the Rope Anchorage Assembly. Attach the Rope Anchorage Assembly into the
Hangar using the Rope Anchorage Shaft as shown in
Figure 6-42
. Firmly reattach the Snap Ring to
the Rope Anchorage Shaft as shown in
Figure 6-43
.
Содержание Harrington RY Series
