KitchenAid KHEV01RSS - Pro Line Plus Electric Dryer, Техническое образование

Страница: 31 / 112

3-3
DRYING AND CYCLE TIPS
Select the correct cycle and dryness level or
temperature for your load. If an Automatic Cycle
is running, the display shows the estimated cycle
time when your dryer is automatically sensing
the dryness level of your load. If a Manual Cycle
is running, the display shows the exact number
of minutes remaining in the cycle.
Cool Down tumbles the load without heat during
the last few minutes of all cycles. Cool Down
makes the loads easier to handle and reduces
wrinkling. The length of the Cool Down depends
on the load size and dryness level.
Drying tips
Follow care label directions when they are
available.
Remove the load from the dryer as soon as
tumbling stops to reduce wrinkling. This is
especially important for permanent press,
knits, and synthetic fabrics.
Avoid drying heavy work clothes with lighter
fabrics. This could cause overdrying of lighter
fabrics, leading to increased shrinkage or
wrinkling.
Cycle tips
Dry most loads using the preset cycle set-
tings.
Refer to the Automatic or Manual Preset
Cycle Settings charts, page 3-5 for a guide
to drying various loads.
Drying temperature and Dryness Level
are preset when you choose an Automatic
Cycle. You can choose a different dryness
level, depending on your load by pressing
the DRYNESS LEVEL button to select
MORE or LESS.
If you wish to adjust the cycle length of a
Manual Cycle, you must press plus (+) or
minus (–) buttons. Adjust the temperature
of a Manual Cycle by pressing TEMP until
the desired temperature is selected.
NOTE: You cannot choose a Dryness Level
with Manual Cycles.
•
•
•
•
•
•
•
STATUS DISPLAY
Messages on the status display help you to
follow the progress of the dryer.
Wet
WET is displayed at the beginning of the
Automatic or Manual Cycle if a wet item is
detected.
In an Automatic Cycle, if a wet item is not
detected after 5 minutes, the dryer goes
directly into Cool Down. COOL DOWN will
be displayed, along with EXTRA CARE, if
selected.
In a Manual Cycle, if a wet item is not de-
tected, the dryer will continue to run for the
length of time selected, but WET will not be
displayed.
Damp
DAMP is displayed if the load has reached the
damp dry level.
NOTE: DAMP will not be displayed with Manual
Cycles.
Cool Down
COOL DOWN is displayed during the cool
down part of the cycle. Laundry cools for ease
in handling.
Cycle Complete
CYCLE COMPLETE is displayed when a drying
cycle is finished. If the Extra Care feature is se-
lected, EXTRA CARE will also be displayed.
The Cycle Complete display turns off 1 hour after
the end of a drying cycle, when PAUSE/CAN-
CEL is pressed, or when the door is opened.
If the Extra Care feature is selected, the Cycle
Complete display will remain on 1 hour after
the Extra Care cycle stops.
•
•