KitchenAid 2003 M, Техническое образование

Страница: 14 / 96

2-4
LOWERING THE LEVELING LEGS
All four leveling legs must contact the floor to
support and stabilize the full weight of the
refrigerator. Rollers are for moving the refrig-
erator, and not for permanent support.
Use a socket wrench to turn the leg levelers on
both sides of the refrigerator to the right (clock-
wise) until the refrigerator weight is supported
by the legs. The rollers should be off the floor.
To avoid cabinet damage, do not apply more
than 50 in/lbs (58 cm/kg) of torque to the
leveling legs.
1 2
1. Rear leveling legs
2. Front leveling legs
LEVELING THE REFRIGERATOR
NOTE: Door panels must be installed before
leveling.
1. Open the doors and place a level on top of
the refrigerator frame. Check to see if the
refrigerator is level from left to right.
2. Use the leveling bolts to adjust the leveling
legs until the refrigerator is level from left
to right.
3. Place a level on the shelves and check to
see if the refrigerator is level from front to
back.
4. Use the leveling bolts to adjust the leveling
legs until the refrigerator is level from front
to back.
5. Make sure that all four leveling legs con-
tact the floor and support the full weight of
the refrigerator.
6. Make a final check to see that the refrig-
erator is level.
ADJUSTING THE DOORS
Door Alignment
Use the following steps to adjust the door
alignment to the left, right, in, or out.
1. Inspect the spacing of the gap between
the freezer and refrigerator doors. Make
sure that the spacing between the doors is
the same distance at the top and bottom.
1
2
2
1. Level to check left to right leveling
2. Level to check front to back leveling
1
2 1
2
1. Rear leveling bolt
2. Front leveling bolt
1
1. Uneven door gap
2. If the door gap is uneven, loosen the four
T27 flat-head mounting screws on top of
both hinges. Loosen the screws to the
point that the hinge is movable, but there
is friction when trying to move the hinge.
NOTE: Do not loosen the two 1/4
″
hex-
head mounting screws.