Pole Pruner/ Palm Harvester
KK-PP2-8627/ KK-PH2-215
: www.kisankraft.com
: +91.80.22178200
Page 21 of 56
Starting method 2:
Remove the chain guard. Position the shaft
on a branch so that it is held by the hook.
Hold the unit firmly with your left hand on
the fan housing
–
your thumb should be
under the fan housing.
Hold the starter grip with your right hand.
Pull the starter grip slowly until you feel it
engage and then give it a brisk strong pull.
Do not let the starter grip snap back. Guide
it slowly back into the housing so that the
starter rope can rewind properly.
Crank the engine until it begins to fire. After
no more than five attempts, turn the choke
knob to
Continue cranking.
Do not pull out the starter rope all the way
–
it might otherwise break.
As soon as the engine runs:
Make sure the carburetor is correctly adjusted. The saw chain must not rotate when the
engine is idling.
Your machine is now ready for operation.
Shut off the engine:
Push the slide control in the direction of the arrow on the stop symbol to STOP.
At very low outside temperatures:
As soon as the engine runs:
Blip the throttle trigger to disengage the starting throttle position. The slide
control moves to the normal run position and the engine settles down to idle
speed.
Open the throttle slightly.
Warm up the engine for a short period.
If the engine does not start:
Choke knob: If you did not turn the choke knob to quickly enough after the engine
began to fire, the combustion chamber is flooded.
Turn the choke knob to .
Set the slide control, lockout lever and throttle trigger to the starting throttle
position.
Start the engine by pulling the starter rope briskly
–
10 to 20 pulls may be
necessary.
Fuel tank run until completely dry:
After refueling, press the fuel pump bulb at least five times
–
even if the bulb is
filled with fuel.
Set the choke knob according to engine temperature.
Start the engine.
