KIRLOSKAR i-HT, Инструкция по установке, эксплуатации и обслуживанию

Страница: 9 / 50

IOM/i_HT Issue Date: 26/06/2009
Page 9 of 50
Last Revision:26/10/2009
d) Missing parts.
e) Pump shaft rotates freely.
Parts or accessories are some times wrapped individually or fastened to the equipment. If
any damage or losses have been incurred; promptly notify your KBL representative, KBL
Dealer and the transport company who delivered the pump.
When unloading pump units, lift equally at four or more points from the base. DO NOT
LIFT ONLY THE DRIVER OR PUMP.
3.2 Preparation
Before installing the pump, clean the suction and discharge flanges thoroughly.
Remove the protective coating from the pump shaft.
If the pump has been in storage and prepared for storage in the manner outlined
previously, remove all the grease from the bearings. The bearings should then be flushed
with carbon tetrachloride or kerosene and relubricated.
3.3 Location
The pump should be installed as near the liquid source as possible, with the shortest and
most direct suction pipe practically.
The pump should be installed with sufficient accessibility for inspection and maintenance.
Ample space and head room should be allowed for the use of an overhead crane or hoist
sufficiently strong to lift the unit.
Make sure there is a suitable power source available for the pump driver. If motor driven,
electrical characteristics should be identical to those shown on motor data/ name plate.
3.4 Foundation
The foundation should be strong enough to reduce vibrations and rigid enough to avoid
any twisting or misalignment.
The foundation should be poured without interruptions to within 20 to 40 mm of the
finished height. The top surface of the foundation should be well scored and glued before
the concrete sets. This provides a bonding surface for the grout. Foundation bolts should
be set in concrete as shown in Fig. 1. Allow enough bolt length for grout, shims, lower