KIRLOSKAR i-HT, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 50

IOM/i_HT Issue Date: 26/06/2009
Page 17 of 50
Last Revision:26/10/2009
5.3 Special care for Bearings
These instructions do not supersede any information issued by the bearing
manufacturers, to whom application should be made for more comprehensive literature
by personnel responsible for bearing care, who with it to make a detailed study.
Care and maintenance of bearings is a matter of ensuring that they are:
a) Correctly lubricated at intervals as laid down in routine maintenance chart.
b) Removed, cleaned and refitted with care.
c) Tools used and work areas should be cleaned.
To remove a bearing, use correctly suited withdrawal equipment.
CAUTION: Damage can be caused by exerting force against the outer ring of a ball
bearing.
Ball bearings should not be dismantled.
Clean bearings thoroughly with an approved fluid.
Dry the bearings by spinning with dry compressed air or by hand. Do not spin a clean dry
bearing.
Inspect the bearing for wear, fractures, cracks, corrosion or other damage which may
necessitate bearing replacement.
Pack both sides of bearing with grease.
Check that the bearing, shaft and housing are cleaned and undamaged.
Recharge with grease to a maximum of two thirds full.
Refit the bearing onto the shaft and press for tap into position.
Pump Model Bearing Module
Bearing DE
Deep Groove
Ball Bearing
Bearing NDE
i -HT 12 XD
3T 6411 6411
i -HT 15 XE
i -HT 15 XF
i -HT 05 AA 1T 6307 6307
i -HT 06 AA 2T 6309 6408