KIRLOSKAR i-HT, Инструкция по установке, эксплуатации и обслуживанию

Страница: 5 / 50

IOM/i_HT Issue Date: 26/06/2009
Page 5 of 50
Last Revision:26/10/2009
2. SAFETY INSTRUCTIONS:
2.1 : General Information
Before performing any actions detailed within this instruction, the Site Health and Safety
instructions must read and fully understood. The instructions in this document also must
be read and fully understood.
Whenever the equipment is operated, maintained or used in any way, the procedures
detailed within the Health and Safety Dossier (DHS) and any procedures detailed within
these instructions shall be followed. The pump supplied by Kirloskar Brothers Limited
(KBL) has been designed with safety in mind, where hazards cannot be eliminated; the
risk has been minimized by the use of guards and other design features. Some hazards
cannot be guarded against and the instructions below MUST BE COMPLIED WITH for
safe operation. These instructions cannot cover all circumstances. It is the responsibility
of the user of the equipment for maintaining safe working practices at all times.
2.1.1 KBL products are designed for installation in designated areas, which are to be
kept clean and free of obstructions that may restrict safe access to the controls and
maintenance access points.
2.1.2 Pump nameplate is fitted to each unit and must not be removed. Loss of this plate
could make identification impossible. This in turn could affect safety and cause difficulty
in obtaining spare parts. Should accidental loss or damage occur, contact KBL
immediately.
2.1.3 Access to the equipment should be restricted to the personnel responsible for
installation, operation and maintenance and they must be trained, adequately qualified
and supplied with the appropriate tools for their respective tasks.
2.1.4 KBL firmly insists that all personnel responsible for installation, operation and
maintenance of the equipment must read safety instructions mentioned in the manual
before any work is done.
2.1.5 Ear defenders should be worn where the specified equipment noise level exceeds
locally defined safe levels. Safety glasses or goggles should be worn where working with