KIRLOSKAR i-HT, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 50

IOM/i_HT Issue Date: 26/06/2009
Page 8 of 50
Last Revision:26/10/2009
b) Remove the glands, packings and lantern rings from the stuffing box if the pump is
equipped in this manner. If the pump is equipped with mechanical seal, dismantle and
coat the seal with light oil.
c) Ensure that suction and discharge branches of the pump and all other openings are
covered with cardboard, wood or masking tape to prevent foreign objects entering the
pump.
d) If the pump is to be stored where there is no protective covering, it is advisable to
cover the unit with a tarpaulin or other suitable covering.
e) The shaft should be manually rotated periodically to prevent pitting of the bearing
surfaces by moisture.
Shearing Hazard.
Do NOT place fingers or hands etc. into the suction or discharge pipe outlets and do
NOT touch the impeller, if rotated this may cause severe injury. To prevent ingress of any
objects, retain the protection covers or packaging in place until removal is necessary for
installation. If the packaging or suction and discharge covers are removed for inspection
purposes, replace afterwards to protect the pump and maintain the safety.
Fill the bearing housing with recommended grease to ensure that the shaft and bearings
remain rust free.
2.6.3.3: Exposed or Extreme Conditions Storage.
For exposed storage or extreme variants in atmospheric or environmental conditions,
please refer to KBL for special storage instructions to suit the conditions acceptable.
3 INSTALLATIONS
3.1 Receiving pump
Upon receipt of the pump, a visual check should be made to determine if any damage
occurred during transit or handling. The main items to look for are:-
a) Broken or cracked equipment, including base, motor or pump feet and flanges.
b) Bent shaft
c) Broken motor end bells, bent eyebolts or damaged boxes of motor