34
INSTALLING – Screen Door, Hood
Hinged grill
1. In the bottom inside corner of post there
are Teardrop slots. As shown in Ref: B.
2. On the Grill there are screws in both
ends. To install, slide the head into one of
the teardrop slots, then slide Grill to
opposite side. These screws may have to
be adjusted for proper alignment, and
length.
3. Install 2 springs on both ends of grill.
Refer to Ref: C. for proper installation.
Hinged bottom panel
1. Ref:E Install two 8-32 x 1/2” screws and
nuts, from the inside of panel with nut to
the outside. Tighten one side only.
2. Thread of loose screw should not
protrude past face of nut.
3. The end of the panel, with tightened
screw can now be slid into teardrop hole
Ref: B
4. Align opposite side of panel with
teardrop Ref:B and tighten screw.
5. Ref:C for spring installation.
Fixed grill and panel
1. In both top and bottom inside corners of
post there are vertical slots, as shown in
Ref: A & B
2. Grills & panels have tabs on both ends.
To install slide the tabs into slots on one
side of post, top side up (Ref:D)
3. Clip opposite side of flat panel into
opposite post. Extra force may be required
to push grill or panel over to clip it in.
Repeat for other fixed grills and panels.
Curtain & Hood Installation
Curtain:
1. Slide curtain onto rods.
2. Slide round end of rod into side post Ref:B
Using two 1/2” DT screws, mount flattened
end of rod to the bottom side of rod hanger
brackets Ref:A, Repeat this step for opposite
side.
3. Mount curtain rod on short side of
fireplace Ref: C. Insert one end into slot on
the inside of post, slide it all the way in, then
slide back to insert into other side of post.
Hood
1. Ref:D Loosen pre-installed 1/2” DT screws
with 1/4” wrench. Slide slotted area of hood
under screws.
2. Tighten screws to finish installation, repeat
this step for all hoods if applicable.
Figure 23
Figure 24
Warning:
Fireplace screen
must be closed while
appliance is in operation.