27
INSTALLING – MVFB4040 Burner Systems and LOGF38
WARNING
The positioning of the logs is critical for the safe
and clean operation of this heater. Sooting and other
problems can occur if the logs are not properly and
firmly positioned in the heater. Never add additional
logs or embellishments such as pine cones, vermiculite,
volcanic rock or rock wool to the heater.
Log Installation
The Kingsman log set has been numbered for ease of installation.
1. Place log #1 onto plate with the ODS Pilot extending through
the notch area. Position holes on under side of Log #1 with the 2
vertical tabs on the plate and lower onto plate.
2. Place log #4 onto plate opposite of plate with the ODS Pilot
3. Position Log #5 onto end Pin of Log #4 as shown in diagram
4. Position Log #3 onto center Pin of Log #4 as shown in diagram.
5. Position log #2 onto Pin of Log #1 and position Log #2 up
against Log #4.
NOTE LOG #5 IS TO BE POSITIONED ON THE NON FLAME SIDE.
Crushed Rock Installation
Place crushed rock onto firebox bottom making sure not to
place any rock onto the burner or burner ports as this will
cause carboning, delayed ignition, and will raise Carbon
Monoxide to very dangerous levels.
Side Brick Panel Installation (Long Side)
1. Remove side brick clip located on top of Firebox.
2. Slide Side Brick Panel into Firebox through the small side
opening and center from left to right and push tight against side
wall of Firebox.
3. Place Brick Clip back into position and tighten
Back Brick Panel Installation (Short Side)
1. Remove back brick clip located on top of Firebox.
2.Slide Back Brick Panel into Firebox through the large side
opening and center form left to right and push tight against side
wall of Firebox.
3. Place Brick Clip Back into position and tighten.
Optional Back and Side Brick Panel Installations
NOTE: BRICK CLIPS CAN BE REPOSITIONED DEPENDING ON TYPE OF INSTALLATION
Figure 21
Figure 20