
30
INSTALLING – GLMVF40 Burner System
1.
Install Optional Brick Liners before installing GLVF40 Burner system.
2.
Remove the Universal Burner Bottom before installing Kingsman Multiview Burner system by removing 4 screws.
3.
Position burner assembly as per unit configuration. Front of Gas Valve should always be accessible after installation.
4.
Tilt burner assembly so valve is at an angle to the Fireplace and lower into position.
5.
Center Burner assembly inside Fireplace and fasten with 2 supplied screws.
6.
Place 8 Grate Bars into Burner System by sliding them into square openings.
NOTE:
After installation of Burner, make sure Log support plates are still in their proper position.
Warning:
Failure to position parts in accordance with these diagrams or failure to use only part specifically
approved with this heater may result in property damages or personal injury.