Kingfisher KI 7010B Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 15 / 46

KI 7010B-UM-11
13
PROGRAM MODE (for FW versions 17.05 & earlier only)
Program mode is a powerful productivity enhancing facility, as it
enables operator to use pre-set routines. The program mode is
particularly useful when performing optical margin testing, since a slow
uniform increase of attenuation can be automatically achieved over a
desired range.
15 different user programs (1 to 9 and A to F) can be set up and stored
in none volatile memory.
To use a previously set up program:
-
Turn the instrument on and press [PROGRAM].
-
Select the desired program with the [-/+] button, press
[SET] and then [GO].
-
Press [STOP] to halt the program, then press [GO] if you
wish to continue.
-
Press [RESTART] to restart the program.
To exit program mode press [STOP], then [MENU].
Setting up Programs:
Select the desired program location:[PROGRAM] [-/+] [SET].
To set up programs, access the hidden control panel by lifting up the
hinged LCD cover.
To set a parameter, press a parameter button on hidden control panel,
then the [-/+] button to select the desired value. The selected value will
be displayed.
To abort the changes, press [CANCEL MEMORY].
You can use the hidden control panel to set up the following
parameters:
Parameter button Parameter
[

]
calibration wavelength
[START] start position
[FINISH] stop position
[STEP] attenuation step
[PERIOD] attenuation step period
When the required parameters have been adjusted, press [SET
MEMORY] to save changes.
NOTE: Programs 1, 5, 6, 7 were pre-loaded in the factory. These can
be changed by the user.