Kingfisher KI 7010B Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 12 / 46

KI 7010B-UM-11
10
GETTING STARTED AND TURNING ON
Pull off instrument connector covers.
To install a connector adaptor, align the locating slot on the side of the
through adaptor with that on the instrument connector, and press it on.
To remove an adaptor, press the release button on the back of the
instrument and then pull off the adaptor. It is easier to pull off the
adaptor with a test lead in place, since this gives better grip.
On older models without the release buttons, move the connector port
to its mid-way point, then pull off the adaptor.
Install the batteries, or plug in external power into the socket at the top
of the instrument.
To switch on the instrument for permanent operation, press and hold
down [Power]
for 3 seconds until ‘ PERM ’ is displayed. Display will
briefly show all segments and then firmware version. Pressing [Power]
again will turn the instrument off.
Should the instrument fail to turn on, it is possible that the
microprocessor needs re-booting. To do this, remove the batteries or
external power for at least 20 seconds, then re-insert to re-boot the
software.
The current attenuation and various user settings remain unchanged
when the attenuator is switched off.
To backlight the display temporarily, press light button ☼ (first button
on the left, top row). To illuminate continuously, press and hold down
light button for 3 seconds.
Note that the hidden keypad is accessed by pulling up the hinged
display cover.
To add the carry strap, slip the end of the strap through the slit on the
curved section at the back of the instrument, and secure the buckle.