KINGFISHER
O W N E R ’ S M A N U A L
w w w . k i n g f i s h e r b o a t s . c o m
44
Fresh Water Systems:
There are two fresh water systems that may be offered;
Cold fresh water system
Hot and cold fresh water system
Cold Fresh Water System:
The cold fresh water system consists of a fresh water holding tank and a demand pump
that is operated by the turning on of the sink tap.
To operate the system:
Fill the fresh water holding tank with fresh water.
The holding tank in a 24’ / 25’
model is located underneath the deck plate on the port side of the boat.
On a 28’ /
30’ boat it is located to the front of the cabin underneath the floor.
The deck fill cap on the 28’ / 30’ models is clearly marked “water” and is located
approximately at the mid point of the boat on the port side gunnel. On the 25’/ 27’
models it is located on the rear port side gunnel. On all models the deck fill cap is
blue in colour.
Ensure that the battery switch is in the correct battery position. (See battery switch)
Turn on the sink faucet, wait a few seconds for the demand pump to prime and
supply water.
The demand pump on a 25’/27’ is located at the back of the water tank and is accessed
through the bilge doors or by removing the deck plate.
On a 28’/30’, the pump is located beneath the center of the main cabin floor and is
accessed by removing the screw out deck port.
When the sink is emptied, the wastewater will be drained overboard by means of a
through hull located half way down the boat on the starboard side.
If the sink pump fails to work, confirm that the battery switch is turned on.
Check the main 30amp fuse and check the fuse under the dash.
Confirm that the battery system is fully charged and functioning and that all wires
leading to the batteries are secured firmly to the battery posts.
Check that the demand pump fuse under the dash has not blown.
Once the above has been checked, if the sink pump is still not working, consult a
Kingfisher dealer.
WARNING
Each Kingfisher is delivered fully winterized. All water system components are
treated with RV anti-freeze. These components
MUST
be flushed out with fresh
water thoroughly before use.
