16
GSM/GPRS/3G/4G/Ethernet/Cloud
LoRa Gateway
Select connected com port,
,COM3,click open com button
,Then click the password (the initial
password is 1234).If the device is successfully connected, the left bottom will turn green and show “connect successfully”. If the
connection is not successful, please verify that the USB connection is good. If the password is incorrectly verified, please check
the port number and password.
3.2Basic setting
Original password:default password is 1234. It is recommended to read the current configuration information before
configuring the parameters, that is, click
and then configure it.
◆
Gateway Device ID:
The device ID is mainly used to identify the gateway in the monitoring center. Can be freely defined, the
range: 0-65536. If the device uses the Modbus protocol, the ID range is fixed at: 1-247, pls note when set.
◆
Gateway Device Description:
It is description of the master, such as: installation address, instructions for use, etc.
Read current time of gateway device
Write the current time of the computer to the master, then the device will run according to this time
Input new password and save gateway settings.
◆
Read Gateway Device Version
:
click
“
Device Version
”,
then can read device model No, version number, IMEI, and
GSM signal values