D
OCUMENT
301900,
R
EVISION
D
E
PI
S
ENSOR
U
SER
G
UIDE
67
7. Insert the single, unjoined end of wire #1 into pin R.
8. Insert the joined end of wire #1/#2 into pin P.
9. Insert the joined end of wire #2/#3 into pin N.
10. Insert the remaining single end of wire #3 into the pin K grommet
alongside the blue wire.
The next step is to wrap the end of wire #3 in pin K around the blue (power
common) wire.
1. Push all but the blue and black wires out of the way.
2. Strip all but 1/4" of insulation off the blue wire.
3. Wrap the black wire around the blue wire and solder into place.
4. Continue inserting the wires into grommet pins as indicated in
Figure 30.
Be sure to follow the EpiSensor end of the schematic
drawing.
To solder the wires into the EpiSensor connector:
1. Start at the bottom and work toward the top (pin A marks the top),
soldering the wires into the connector.
Note
: When cool, the soldered joints should have a smooth, shiny
surface. Use enough solder to just fill the connector cup.
2. Then slide the grommet forward and up against the connector head
(shown on the right side Figure 40).
3. Apply two turns of insulating PVC tape between the back of the
grommet and the foil tape (also shown in Figure 40).
Figure 40: Connection wrapped with PVC tape
4. Now, between the back of the grommet and the end of the cable
outer jacket, tightly wrap 1" x 3" foil tape around the cable, as
shown in Figure 41.
