To the Owner
CAUTION: TO REDUCE THE RI�K OF ELECTRIC
�HOCK, DO NOT REMOVE COVER (OR
BACK) . NO U�ER-�ERVICEABLE PART�
IN�IDE EXCEPT LAMP REPLACEMENT .
REFER �ERVICING TO QUALIFIED
�ERVICE PER�ONNEL .
THIS SYMBOL INDICATES THAT DANGEROUS
VOLTAGE CONSTITUTING A RISK OF ELECTRIC
SHOCK IS PRESENT WITHIN THIS UNIT.
THIS SYMBOL INDICATES THAT THERE ARE
IMPORTANT OPERATING AND MAINTENANCE
INSTRUCTIONS IN THE OWNER'S MANUAL
WITH THIS UNIT.
CAUTION
RI�K OF ELECTRIC �HOCK
DO NOT OPEN
Before installing and operating this rojector, read this
manual thoroughly.
This projector provides many convenient features and
functions. Operating the projector properly enables
you to manage those features and maintains it in good
condition for many years to come.
Please revise this manual for proper operation & cable
connections in case your projector doesnot work
properly, try solutions on
Trouble�hooting
. If problems
still persist after following all operating instructions,
contact the dealer where you purchased the projector or
the service center.
The projector lamp is a consumable part. It's normal
the brightness reduces gradually and will be lower than
new one after working for a period of time. Please turn
on/off the projector strictly by the following the steps
as described in the
Turn On the Projector
and
Turn
Off the Projector
in this manual, maintain and clean
regularly as per required specified in
Maintenance and
Cleaning
, otherwise, the lamp residual heat may result
in shorten the service life of the projector and lamp
greatly, even damage them in a short time.
�afety Precaution
CAUTION
DO NOT SET THE PROJECTOR IN GREASY, WET, OR SMOKY
CONDITIONS SUCH AS IN A KITCHEN TO PREVENT A
BREAKDOWN OR A DISASTER. IF THE PROJECTOR COMES
IN CONTACT WITH OIL OR CHEMICALS, IT MAY BECOME
DETERIORATED.
READ AND KEEP THIS OWNER'S MANUAL FOR LATER
USE.
WARNING:
•
THI� PROJECTOR MU�T BE EARTHED .
•
TO REDUCE THE RI�K OF FIRE OR
ELECTRIC �HOCK, DO NOT EXPO�E THI�
APPLIANCE TO RAIN OR MOI�TURE .
– This projector produces intense light from the projection
lens. Do not stare directly into the lens, otherwise eye
damage could result. Be especially careful that children
do not stare directly into the beam.
– Install the projector in a proper position. Otherwise it
may result in fire hazard.
– Allowing the proper amount of space on the top, sides,
and rear of the projector cabinet is critical for proper air
circulation and cooling of the unit. The dimension shown
here indicate the minimum space required. If the
projector is to be built into a compartment or similarly
enclosed, these minimum distances must be
maintained.
– Do not cover the ventilation slot on the projector. Heat
build-up can reduce the service life of your projector,
and can also be dangerous.
– If the projector is unused for an extended time, unplug
the projector from the power outlet.
– Do not project the same image for a long time. The
afterimage may remain on the LCD panels by the
characteristic of panel.
�IDE and TOP
Back
�afety In�truction�
0.7’(20cm)
1.5’(50cm)
3’(1m)
3’(1m)
20cm
50cm
1m
1m
PLC-EN.indd
00-11-1 ::0
