Kimray GEN II, Руководство по ремонту

Страница: 6 / 22

STEP 3
Pull out on Variable Link Knob and slide
off of Tangent Arm (Fig 1.4).
Using a flat blade screwdriver pry off
lower end of Variable Link Knobs yoke.
Do not turn the Link Arm for it is set at
factory (Fig 1.5).
STEP 4
Remove retainer Snap Rings from Pivot
Post (Fig 1.6).
STEP 5
Remove Adjustment Lever and Leaf
Spring assembly by pulling out on spring
then slide Adjustment Lever off (Fig 1.7)
and (Fig 1.8).
1. Slide out
2. Slide back
STEP 6
Remove Pivot Plate Screws and pull Pivot
Rod out (Fig 1.9) and (Fig 1.10).
Remove Screws
STEP 7
Remove Coupling on end of Terminal Arm
(Fig 1.11).
This step is optional if you cannot get a
wrench around housing. Remove Arm
Post only to make clearance for wrenches
(Fig 1.12).
www.kimray.com
Page 4
GEN II REPAIR MANUAL
Terminal Arm DISASSEMBLY
Figure 1.4 Figure 1.5
Figure 1.6
Figure 1.7 Figure 1.8
Figure 1.9 Figure 1.10
Figure 1.12 Figure 1.11
Knob
Pry here