Sirius Capacitor Module
–
User Manual
Model Number -7100-48-B-2C-M-SD-A-G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
16
9.
F12 Terminals:
These are the output terminals of the Module having electronic switch protection that is limited to 100VDC
only.
F12 terminals are used to connect the load or charger to the Module. There are also positive and negative
cables in the jumper cable set. The
red
one is positive (+), the
black
one is negative (-).
3.
Module Installation:
3.1 Inspection:
Inspect the shipping carton for visible damage including cracks, dents, deformation and other visible
abnormalities prior to unpacking the Module. Document (photograph) any damage and report this to your
Reseller as well as to the shipping agent immediately. Remove the Module from the shipping carton and retain
the shipping materials until the unit has been inspected and is determined to be operational.
3.2 Safety Gear:
Installation must strictly follow the national safety regulations in compliance with the enclosure, installation,
creepage, clearance, casualty, markings and segregation requirements of the end-use application. Installation
must be performed by professional installers only. Switch OFF the system and check for hazardous voltages
before altering any connection! Sirius Modules must be handled only by qualified and trained personnel.
Installation should not exert bending or twisting torque to the Module enclosure.
Note!
Read the safety Instruction section before installation.
Never connect the red cable to the negative terminal of
the Module.
