Sirius Capacitor Module
–
User Manual
Model Number -7100-48-B-2C-M-SD-A-G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
12
1.
Circuit Breaker:
Circuit breaker
is used to power ON the Module. It also acts as a second line of protection, if the circuit fails to
protect the Module from over current, the circuit breaker will trip.
2.
Bypass Circuit Breaker:
The Bypass Circuit breaker is used to bypass electronic switch. It is used for Series connection and recovery of
the Module.
3.
Fault Reset:
Fault Reset is a push button which is used to turn ON the terminal manually after it turns OFF due to any error.
The additional features of fault reset are as follows:
a)
Hold fault reset for 5 seconds to toggle the terminal.
b)
Hold fault reset for 3 seconds to reset fault if there is/are any.
c)
We can set the Current reading to zero.
d)
Press fault reset button to check the state of charge and instantaneous power.
e)
Press the fault reset button to see the individual cell voltages.
•
Checking for Individual Cell Voltages:
When the fault reset button is pressed, the LCD after displaying the state of charge (SOC) and instantaneous
power, will display the cell voltages of the first four cells as shown below:
Whereas:
01=Voltage of 1
st
Cell
02=Voltage of 2
nd
Cell
03=Voltage of 3
rd
Cell
04=Voltage of 4
th
Cell
By continuously pressing, the cell voltages will be displayed for all the cells.
•
Enabling/Disabling Cell Balancing:
After scrolling through the individual cell voltages, cell balancing can be enabled/disabled by the following
steps below:
Step 1:
When current is zero, LCD will display the message as illustrated below.
