Kikusui PLZ-30F, Инструкции по эксплуатации, Страница: 109 / 192

PLZ-U Remote Control 6-17
6.5.2 Channel Commands
Channel commands select the load unit channels. For the de fi nition of channel num-
bers, see section 4.1, “Panel Control Basics.”
Selecting a channel
• This command selects the channel to which commands are applied. It does not
switch the channel display LED on the frame.
To perform the same operation as the ENTRY key on the panel, the INST:FOC
command must be executed at the same time.
INST
Selects the channel to which commands are applied using an ID. Or, queries the cur-
rent setting.
Set command: INSTrument[:SELect]
{CH1|CH2|CH3|CH4|CH5}
Query command: INSTrument[:SELect]?
INST:NSEL
Selects the channel to which commands are applied using a number. Or, queries the
current setting.
Set command: INSTrument:NSELect {1|2|3|4|5}
Query command: INSTrument:NSELect?
Specifying multiple channels
INST:COUP
Speci fi es the applicable channels when applying commands to multiple channels.
Or, queries the current setting.
• Be sure to execute INST:COUP at the same time as INST or INST:NSEL.
If channels speci fi ed by INST or INST:NSEL are not included in the channels
speci fi ed by INST:COUP, commands will not be applied to multiple channels.
Set command: INSTrument:COUPle {<list>|ALL|NONE}
Query command: INSTrument:COUPle?
• Program data
Value <list> CH1, CH2, CH3, CH4, CH5
ALL Speci fi es all
NONE Not specify
Example) When applying commands to CH1 and CH3
INST CH1
INST:COUP CH1,CH3
NOTE
NOTE