1 x
Lower Front Back 5/8 x 4-1/2 x 76-7/8”
1 x
Upright Short 1-1/4 x 3 x 38”
1 x
Upright Long 1-1/4 x 3 x 61”
1 x
Floor Support Long 1-1/4 x 3 x 74-3/8”
021
023
022
024
Note: It is important to note hole orientation for the following step.
A:
Place (021) Lower Front Back so that one end is over (023) Upright Long and the other end is over (022)
Upright Short. Attach each end using 1 (H2) 1/4 x 2” Hex Bolt (with lock washer, flat washer and t-nut) and 1
(S20) #8 x 1-3/8” Wood Screw making sure to note hole orientation. (fig. 2.1 and fig. 2.3)
B:
Place (024) Floor Support Long so that one end is under the middle holes on (023) Upright Long and the other
end is under the end of (022) Upright Short. Attach each end using 1 (H3) 1/4 x 2- 1/2” Hex Bolt (with lock washer, flat
washer and t-nut). Check to make sure that assembly is square. (fig. 2.1 and fig. 2.2)
16
Wood Parts
Hardware
Step 2: Back Wall Assembly
2 x 1/4 x 2” Hex Bolts
(1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
2 x
#8 x 1-3/8” Wood Screw
2 x
1/4 x 2-1/2” Hex Bolt
(1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
H2
H3
S20
Fig. 2.1
S20
H2
Fig. 2.3
1/4” Flat
Washer
1/4” Lock
Washer
1/4” T-Nut
H3
Fig. 2.2
1/4” Flat
Washer
1/4” Lock
Washer
1/4” T-Nut
022
022
024
021
023
024
021
022
S20
H2
H2
1/4” Flat
Washer
1/4” Flat
Washer
1/4” Lock
Washer
1/4” Lock
Washer
1/4” T-Nut
1/4” T-Nut
1/4” T-Nut
Note hole
orientation
S20
H3
34-3/8”
(873mm)