KI Extol, Инструкция по сборке и руководство пользователя

Страница: 6 / 12

6
Extol
™
Auditorium Seating
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Aisle Light Attachment
1. Remove the four #14 x 1
1
/
2
” wood
screws securing the end panel
to the upright and move the end
panel aside (Figure 5).
Note: The LED aisle light wiring
is to be connected to a 12VDC
Class II power supply by a
qualified electrician who must
check the electrical integrity of
the finished system. The steps
below are intended as a guideline
for installation. All local codes
must be followed.
2. Place the aisle light tube into the
aisle light housing and align the
LEDs to show down through the
opening in the bezel (Figure 5).
3. Route the aisle light wiring first
through the outside end panel
hole, next into the outside upright
hole, down the inner cavity of the
upright and out the lower inside
upright hole (Figure 5).
4. Attach the aisle light housing with
light tube/wiring to the side of the
end panel using two #10 x
1
/
2
”
T-25 Torx screws and #10 locking
nuts (Figure 5).
5. Place the end panel back into
position while carefully pulling
aisle light wiring through the
inside of the upright. From the
inside, re-assemble the end
panel to the upright with screws
removed in step 1 (Figure 5).
6. Next, route the power wire
through the 90° metal connector
and through the
3
/
8
” x 16” flexible
conduit and out. Attach the
conduit to the connector and
the connector to the inside of
the upright. Connect the power
wires to a 12VDC Class II Power
supply.
Important:
Observe polarity when wiring.
+ (positive) is the copper wire
- (negative) is the silver wire