KI Extol, Инструкция по сборке и руководство пользователя

Страница: 5 / 12

Extol
™
Auditorium Seating
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
5
Back Attachment - cont.
4. With the bottom of the back
bracket nested on the screws,
rotate the top of the back
assembly forward and align the
desired set of upper holes in the
back bracket with the holes in the
top of the upright bracket
(right-end). At this time, loosely
insert the M6 x 6mm cap screw
to hold the back bracket to the
right-end upright (Figure 3).
5. To install a second back assembly
in a row, first insert a M6 x 6mm
cap screw through the bottom rear
hole in the next shared upright
and loosely twist on a M6 nut
(Figure 4).
6. Lift up and rotate the back
assembly in between the two
uprights until the appropriate two
slots in the lower part of the back
brackets nest onto the two loosely
attached M6 x 6mm cap screws
in the two shared uprights’ back
brackets (Figure 4).
7. As in step 4 above, rotate the top
of the back assembly forward
and align the desired set of upper
holes in the back bracket with
the holes in the top of the upright
bracket (shared). At this time,
insert loosely the M6 x 6mm cap
screw to hold the back brackets
of both back assemblies to the
common shared upright
(Figure 4).
8. Continue on following the steps
above until reaching the end of
the row, then secure the final seat
to the left-end upright similar to
the right-end upright.