32 Installation Note N5242-90120
All Instruments
-
Step 14. Install the Test Set Cables
To see an image showing the location of these cables, click the appropriate
Chapter 6 bookmark (Ex: “2-Port Configuration, Options 224/029”) in the PDF
Service Guide. New parts are listed in
1.
Connect the following wire harness and ribbon cables:
-
①
—A42 port 1 receiver attenuator to A19 test set motherboard J205
-
➁
—A34 port 1 source attenuator to A19 test set motherboard J201
-
③
—A45 port 2 receiver attenuator to A19 test set motherboard J208
-
④
—A37 port 2 source attenuator to A19 test set motherboard J204
-
⑤
—A53 port 2 bridge to A55 noise downconverter J11
-
⑥
—A52 port 1 bridge to A55 noise downconverter J10
-
⑦
—A55 noise downconverter J1 to A19 test set motherboard J548
2. Install the following semi-rigid cables in the order listed. Use a 5/16-in
torque wrench set to 10 in-lbs to tighten all cable connectors.
For all analyzer serial numbers
- W135(N5242-20278) Front-panel Port 2 RCVR B IN to A45 port 2
receiver attenuator
- W129(N5242-20293) A53 port 2 bypass switch to A54 port 2 bridge
- W128(N5242-20303) A53 port 2 bypass switch to front-panel Port 2
SOURCE OUT
- W130(N5242-20302) A53 port 2 bypass switch to A54 port 2 bridge
Follow instructions carefully when making cable connections, especially
wire harness connections. Incorrect connections can destroy components,
resulting in additional customer costs.
Be careful not to damage the center pins of the semirigid cables. Some
flexing of the cables may be necessary but do not over-bend them.
Use a 5/16-in torque wrench set to 10 in-lbs on all cable connections
except the front and rear panel bulkhead connectors. On these, use a 9
mm nutsetter or open end torque wrench set to 21 in-lb.
Some of these cables may have different dimensions from those shown in
the graphics.
Содержание PNA-X N5241B
