6
Using N8480 Series Power Sensors
194
Keysight N1913/1914A User’s Guide
Enter (or edit) the frequency and cal factor pairs as follows:
1
Press
to add a new frequency value (or press
to edit). Use the
numeric keypad to enter the required value in the
Frequency
pop-up window.
Complete the entry by pressing the
,
keys.
2
Enter the new cal factor value (or press
to edit). Use the numeric
keypad to enter the required value in the
Cal Factor
pop-up window. Complete
the entry by pressing the
key.
3
Continue adding or editing values until you have entered all the data you
require.
4
When you have finished editing the table press
to save the table.
NOTE
A calibration factor in the range of 1% to 150% can be entered.
The following rules apply to naming sensor calibration tables:
– The name must consist of no more than 12 characters.
– All characters must be upper or lower case alphabetic characters, or numeric
(0-9), or an underscore (_).
– No other characters are allowed.
– No spaces are allowed in the name.
Insert
Change
GHz MHz
Change
%
Done
NOTE
Ensure that the frequency points you use cover the frequency range of the
signals you want to measure. If you measure a signal with a frequency outside
the frequency range defined in the sensor calibration table, the power meter
uses the highest or lowest frequency point in the sensor calibration table to
calculate the offset
Содержание 1914A
