U3020AS62
Front and Rear Panel Features
Front and Rear Panel Features
Figure 2
Front Panel
LAN Reset
The LAN reset button restores the instrument's default LAN configuration.
Port Select LEDs
The LEDs indicate the RF Port path that is presently operational, all other port inputs are
terminated by an internal 50 Ohm load.
Input/Output Ports
There are two separate signal channels, A and B. Each channel has one output port and six input
ports. All connectors are 3.5 mm female.
Instrument State LEDs
When the power is applied to the U3020AS62, the instrument enters its power-on sequence
which requires several seconds to complete. The LEDs provide information on the state of the
instrument during power-on and during upgrades of the instrument firmware.
identifies the instrument states based on the color and functioning of the LEDs.
Standby Switch
Note that this switch is Standby only, not a line switch. The main power cord can be used as the
system disconnecting device. It disconnects the mains circuits from the mains supply.
Output
Ports
Standby
Switch
LAN Reset
Port Select LEDs
Input Ports
10
Keysight U3020AS62 User's and Service Guide
Refer to the standard instrument documentation for damage limits to the
ports. Verify that your test setup will not cause those limits to be exceeded.
Instrument State LEDs
