KEYLESS KE-350, Инструкция по установке и эксплуатации

Страница: 16 / 29

KE-350 Installation and Operations Manual
Programming System Setup
The KE-350 System Setup can only be modified by the Master Code
holder. When the system is initially setup, the default system settings
should be reviewed and necessary modifications should be made prior to
other programming.
1.
Enter
✼
3
2.
Enter the Master Code, followed by #
Example:
✼
3 123 #
This opens programming and causes Ö
3.
Proceed to one of the following options which requires programming:
Red LED Green LED
Slow Flash Solid
Keypad Status after Step Completion
To Change the Master Code (Default: 1 2 3)
a) Enter 1#
b) Enter the New Master Code, followed by #
c) Reenter the New Master Code, followed by
d) Return to Step 3
(Notes on the Master Code: If you forget the Master Code, press “PGM SW” on the Control Module for 3
seconds (make sure the 5 dip switches are OFF). This will take you to Step 3 of system setup programming.
See page 8 for additional information.)
Setting the Door Open Time (Default: 5 sec.)
a) Enter 2 #
b) Enter the desired Door Open Time in two
digits (01 to 99 seconds) followed by #
c) Return to Step 3
Example: 2 # 1 5 #
Ö Set a 15 second Door Open Time
Setting Latching Option (Default: OFF)
a) Enter 3 #
b) Select the desired latching method:
Off Ö Enter 9900, followed by #
Step
;
Beep Red LED Green LED
a) Double Slow Flash Slow Flash
b) Double Slow Flash Fast Flash
c)
Triple Slow Flash Solid
Step
;
Beep Red LED Green LED
a)
Double Slow Flash Fast Flash
b) Triple Slow Flash Solid
Step
;
Beep Red LED Green LED
a) Double Slow Flash Fast Flash
b) Triple Slow Flash Solid
Manual
Ö
Enter 9901, followed by #
Timed Ö Enter the desired time (hour/minute) in four digits (24 hour), followed by #
c) Return to Step 3
Example: 3 # 1 7 0 0 #
Ö Set timed latching at 5:00 p.m.
13