14
Flame detection temperature parameters.
These parameters specify operation of the temperature detector of burner fuel
ignition. If the system is fitted with optical fire burner detector, parameters change
and viewing is unavailable.
1.10 Burner measured temperature
– this parameter displays the current
measured burner temperature.
1.11/1.12 Burner temperature with fuel ignited
– if ignition temperature is equal or
higher than this desired setting, the controller will switch off the lighter and assume
that ignition was provided.
Flame optical detection parameters.
These parameters specify operation of burner flame optical detector. If the system is
fitted with flame temperature detector, parameters change and viewing is unavailab-
le.
1.13 The current furnace brightness determined by an optical detector
– this
parameter displays the current flame brightness measured by the optical detector.
1.14 Brightness when fuel ignition has occurred
– if the optical detector reading
will be equal or higher than this desired setting, the controller will switch off the igni-
ter and assume that ignition has occurred.
Information on burner work.
Parameters described below refer to counters that accumulate information on opera-
tion of the burner since its first start. It is not possible to cancel counter readings.
1.15 Burner work time
– reading of this counter defines burner work time. The
counter updating follows after total working hour of the device at maximum or
minimum power.
