17
6-3. Setting the Measurement Mode
There are two measurement modes: "Normal measurement mode" and "Continuous measurement
mode." Immediately after pressing the
key and turning on the power, the unit will be set to
"Normal measurement mode." If the unit is set to "Continuous measurement mode," measurements can
be made without pressing the
key for each measurement.
(1) Setting the continuous measurement mode
In step "6-2. Measurement Method (4)," press the
key.
The decimal point will blink, and the moisture value and bar
graph will be displayed.
* If the paper is not held against the sensor electrodes, and if the
measured value is outside of the measuring range, either "HI" or "LO"
will be displayed, and the decimal point will blink.
(2) Canceling the continuous measurement mode
Press the
key, and a "beep" will sound. The display
will momentarily go blank, and the unit will return to normal
measurement mode.
* Pressing the
key turns off the power and automatically
cancels this mode.
* Note that the battery life is shorter in continuous measurement mode.
*The
symbol denotes a blinking display.
