www.kesseboehmer.de
24
Fehlermeldungen am Display der Handschalter / Error messages on the display of the handset
6 Error messages on the display of the handset
The display shows E and an error code.
The display shows HOT.
Cause
Remedy
The motor control system has activated the
overheating protection due to overheating.
Wait until the motor control system has cooled
down and the HOT message on the display goes
off.
Number Description
Remedy
00 Internal Error Channel 1
01 Internal Error Channel 2
02 Internal Error Channel 3
12-14 Short circuit in the system
24+25+26+ Overcurrent in the motor
48+49+62 Table overloaded
36-38 Plug detection
A motor was disconnected
55+56 Column synchronization lost
Turn off the motor control system and contact
support.
Locate the short circuit
- Replace the motor cable
- Replace the columns
- Replace the control system
Remove the jammed objects.
Reduce the working load.
Plug in the missing motor again.
Check the connectors (control system motor
cable and column motor cable).
Perform a reset.
Perform a reset.
If this error occurs frequently, the load
distribution should be checked.
An incorrect recognition of the motors can be reversed by a „factory reset“.
A&er the reset, proceed as described in 5. Operation (page 16).
Notice
