HyCut Mower
EN
2021-01-27
47 / 67
Fig. : Pulling up the drive chain18
4
deflection steering wheel in front
5
Sliding element
6
Drive wheel
7
Rear steering wheel
8
Locking Pin
9
Hand clamping device
10
connecting bolts
11
rollers
4.
Turn the hand clamping device (9) together and re-energise the sliding
element (5) completely.
5.
Open the locking pin (8) of the connection bolt (10) and pull it out of the
connection bolt (10).
6. Pull out
the connecting bolt (10) from the hand clamping device (9).
7.
Swivel the hand clamping device (9) one-sided upwards and push the
sliding element (5) as far as possible into the carrier of the rollers (11).
8.
Place the drive chain from the bottom on the rollers (11).
9.
Guide the drive chain over the two deflection wheels at the front (4) and rear
(7).
10.
Finally place the drive chain on the drive wheel (6).
11.
Push the sliding element (5) out by hand as far as possible.
12.
Swing the hand clamping device (9) back and connect to the frame using
the connecting bolt (10).
13.
Insert and close the locking pin (8).
