KEP MINI-BATCHER MB2, Инструкция по установке и эксплуатации

Страница: 19 / 26

15
DISPLAY REMARKS
pre b
factor
count
rate
loc
LC PG
or
LC ALL
CoDE
Flashes
followed by:
#####
CoDE
Flashes
followed by:
0
LoC
or
uN LoC
This section of the menu is used to set up
the lockout type and code number.
LC PG = Locks program but presets and
reset are accessible. (see description)
LC ALL= Locks all keypad buttons except
START, STOP & VIEW.
Press the PRGM button to toggle between
choices; Press ENTER to enter displayed
choice.
After CODE flashes the display will show the
existing lock code. To change the code press
the key under each digit to be changed. Press
ENTER to enter displayed value.
(see below to turn lock ON or OFF)
Key in the lock code (see programming step
4) by pressing the keys under the digits to be
changed. Press the ENTER key to enter the
displayed code.
After the code is entered the unit will display
LOC (unit is locked) or UN LOC (unit is un-
locked). This message will be displayed for
approximately 3 seconds before the unit re-
turns to the run mode.
PRESS
SETTING
LOCK
STEP
5
E N
PROGRAMMING
(continued)
E N
SETTING
THE
LOCK
STATUS
E N